The Signature is a one of a kind pedal that I created that is capable of going from clean to a massive amount of dynamic overdrive. After extensive experimentation with the circuit, using a Tubescreamer at it's base, I finally achieved what I wanted in a bass overdrive. It has an internal charge pump that takes a standard 9 volt power supply and runs the circuit at 18 volts ( so DO NOT power it with a power supply higher than 9 volts!) The controls are Gain, Tone and Level (volume) with a presence and a low cut switch (activated in the down positions). It comes in a polished and acid etched 1590B2 enclosure (a 4mm deeper 1590B) with all top jacks with a programmable relayed true bypass
Bypass instructions:
Engage / Bypass: When bypassed, the sound signal will go directly from your input to your output jacks. Tap
the foot switch to engage the effect and route the signal to your audio PCB. When engaged, tap the foot
switch again to switch to bypass.
Temporary Bypass/Engage: Holding the foot switch while the effect is engaged will temporarily bypass it,
and it will re-engage when you lift your foot. Similarly, holding the foot switch while bypassed will
temporarily engage it.
It will, by default, remember whether the effect is engaged or bypassed and recall
this setting on power on. If instead you want the effect always on, or always off when powered on, hold the
switch while powering on to toggle its behavior. The LED will blink to indicate the change. 3 blinks for auto on,
4 blinks for auto-off, and 5 blinks for memory.
